2013 Dodge P0301: What It Means & Is It Safe to Drive?
P0301 on the 2013 Dodge: Cylinder 1 Misfire Detected. Here's what it means, what usually causes it, what repairs typically cost, and whether it's safe to keep driving.
PowertrainHigh urgency
What this code means
The PCM has detected a misfire specifically on cylinder 1. Similar to P0300, but pinned to a single cylinder.
Common causes on the 2013 Dodge
- Worn or fouled spark plug on cylinder 1
- Failing ignition coil or coil-on-plug
- Leaking or clogged fuel injector
- Low compression in cylinder 1
Symptoms
- Check Engine Light (often flashing when misfire is severe)
- Rough idle or shaking, especially at low RPM
- Loss of power under load
Typical fixes
- Replace spark plug and/or coil on cylinder 1
- Test and clean or replace the injector
- Perform compression test and repair internal issues if needed
Repair cost range
For a 2013 Dodge, repairs for P0301 typically fall between $150 and $900, depending on the root cause and labor rates in your area.
Known issues on Dodge
Dodge's 3.6L Pentastar shares the cam follower wear issue with Jeep. On MDS-equipped 5.7L HEMI engines, a P0301 can indicate a failed MDS solenoid or lifter on cylinder 1. Inspect oil condition and listen for a lifter tick alongside the misfire code.
Most commonly affected models
Charger 3.6L Pentastar 2011–2020Challenger 3.6L 2011–2020Durango 5.7L HEMI MDS 2011–2020