What does code P0171 mean on a Dodge and is it safe to drive?
P0171: System Too Lean (Bank 1). Here's what it means on your Dodge, what usually causes it, what repairs typically cost, and how safe it is to keep driving.
What this code means
The engine is getting too much air relative to fuel. The O2 sensor sees excess oxygen in the exhaust and the PCM is adding more fuel than normal to compensate.
Common causes for your Dodge
- Dirty or faulty mass airflow (MAF) sensor
- Vacuum leaks (PCV hose, intake gasket, brake booster)
- Weak fuel pump or clogged fuel filter
- Leaking or stuck open fuel injectors (less common)
Symptoms
- Check Engine Light
- Rough idle, hesitation, lack of power
- Possible spark knock under load
- Poor fuel economy
Typical fixes
- Clean or replace MAF sensor
- Locate and seal vacuum leaks
- Replace fuel filter / test fuel pressure
- Smoke test intake system
Repair cost range
For a Dodge, repairs for P0171 often fall between $50 and $500, depending on the cause and whether you use OEM or aftermarket parts. Labor rates vary by location.
Known issues on Dodge
Dodge P0171 on 3.6L Pentastar V6 shares the same intake runner seal degradation as Jeep. On Dart 2.4L Tigershark, the intake manifold flap actuator vacuum hose is a known failure point—it develops micro-cracks that allow unmetered air. On Journey 3.5L V6 (ERB engine), the intake manifold gaskets between the upper and lower plenum are a recurring leak source. On all Hemi V8 engines (5.7, 6.4), check the MAF sensor calibration and intake air temperature sensor—Hemi MAF failures are less common but do occur after 120k miles.
Most commonly affected models