2006 Jeep P0131: What It Means & Is It Safe to Drive?
P0131 on the 2006 Jeep: O2 Sensor Circuit Low Voltage (Bank 1, Sensor 1). Here's what it means, what usually causes it, what repairs typically cost, and whether it's safe to keep driving.
What this code means
The upstream oxygen sensor on Bank 1 is reporting a voltage signal below the expected range. This can indicate a faulty sensor, a lean condition, or an exhaust leak near the sensor.
Common causes on the 2006 Jeep
- Failed upstream oxygen sensor
- Exhaust leak before the sensor
- Lean fuel condition (vacuum leak, weak fuel pressure)
- Damaged sensor wiring or ground
Symptoms
- Check Engine Light
- Poor fuel economy
- Rough idle in some cases
- Failed emissions test
Typical fixes
- Replace upstream oxygen sensor (Bank 1, Sensor 1)
- Locate and fix exhaust leaks
- Smoke test for vacuum leaks
- Check fuel pressure
Repair cost range
For a 2006 Jeep, repairs for P0131 typically fall between $100 and $350, depending on the root cause and labor rates in your area.
Known issues on Jeep
Jeep P0131 on Pentastar engines typically points to a worn upstream O2 sensor on Bank 1 or a small exhaust leak near the sensor. On older Wrangler TJ with the 4.0L I6, P0131 often means the O2 sensor is contaminated from an occasional rich cold-start condition.
Most commonly affected models