2008 Mitsubishi P0306: What It Means & Is It Safe to Drive?
P0306 on the 2008 Mitsubishi: Cylinder 6 Misfire Detected. Here's what it means, what usually causes it, what repairs typically cost, and whether it's safe to keep driving.
What this code means
Misfire on cylinder 6, found on V6 and V8 engines. On transversely-mounted V6 engines the rear bank cylinders (including cylinder 6) often have higher labor costs due to access difficulty.
Common causes on the 2008 Mitsubishi
- Worn spark plug on cylinder 6
- Failed coil-on-plug
- Fuel injector fault
- Low compression
Symptoms
- Check Engine Light, may flash under load
- Rough idle or vibration
- Hesitation and power loss
Typical fixes
- Replace spark plug and COP coil on cylinder 6
- Replace or clean injector on cylinder 6
- Compression and leak-down test if no improvement
Repair cost range
For a 2008 Mitsubishi, repairs for P0306 typically fall between $150 and $1200, depending on the root cause and labor rates in your area.
Known issues on Mitsubishi
Mitsubishi V6 P0306 on cylinder 6 (last rear-bank cylinder) requires intake manifold removal for coil access on 6G75 and 6G72 engines. Inspect the spark plug and coil boot condition while the intake is off. Replace the plug and coil together to avoid repeat disassembly.
Most commonly affected models