2020 Mitsubishi P0306: What It Means & Is It Safe to Drive?

P0306 on the 2020 Mitsubishi: Cylinder 6 Misfire Detected. Here's what it means, what usually causes it, what repairs typically cost, and whether it's safe to keep driving.

PowertrainHigh urgency

What this code means

Misfire on cylinder 6, found on V6 and V8 engines. On transversely-mounted V6 engines the rear bank cylinders (including cylinder 6) often have higher labor costs due to access difficulty.

Common causes on the 2020 Mitsubishi

  • Worn spark plug on cylinder 6
  • Failed coil-on-plug
  • Fuel injector fault
  • Low compression

Symptoms

  • Check Engine Light, may flash under load
  • Rough idle or vibration
  • Hesitation and power loss

Typical fixes

  • Replace spark plug and COP coil on cylinder 6
  • Replace or clean injector on cylinder 6
  • Compression and leak-down test if no improvement

Repair cost range

For a 2020 Mitsubishi, repairs for P0306 typically fall between $150 and $1200, depending on the root cause and labor rates in your area.

Known issues on Mitsubishi

Mitsubishi V6 P0306 on cylinder 6 (last rear-bank cylinder) requires intake manifold removal for coil access on 6G75 and 6G72 engines. Inspect the spark plug and coil boot condition while the intake is off. Replace the plug and coil together to avoid repeat disassembly.

Most commonly affected models

Endeavor 3.8L 6G75 2004–2011Eclipse V6 3.8L 2006–2012Outlander 3.0L 6G72 2004–2006

Is it safe to keep driving your 2020 Mitsubishi with this code?

For driving-safety guidance—how far you can go, when to tow, and what's urgent—see these checklists:

See all codes for your Mitsubishi

Looking for a different code, or want the full guide without the year filter?