What does code P0325 mean on a Nissan and is it safe to drive?
P0325: Knock Sensor 1 Circuit Malfunction (Bank 1). Here's what it means on your Nissan, what usually causes it, what repairs typically cost, and how safe it is to keep driving.
What this code means
The PCM isn't receiving a valid signal from knock sensor 1. Without knock feedback, the PCM retards ignition timing as a safety measure, reducing power and economy.
Common causes for your Nissan
- Failed knock sensor
- Corroded or broken wiring/connector at the sensor
- Actual engine knock from carbon buildup or low-octane fuel
Symptoms
- Check Engine Light
- Reduced power and fuel economy (PCM retards timing)
- Possible audible knock or ping under load
Typical fixes
- Replace knock sensor
- Repair wiring and connector
- Use correct octane fuel and address carbon buildup
Repair cost range
For a Nissan, repairs for P0325 often fall between $150 and $500, depending on the cause and whether you use OEM or aftermarket parts. Labor rates vary by location.
Known issues on Nissan
Nissan P0325 on VQ35DE 3.5L V6 engines is primarily a harness connector issue—the knock sensor is mounted under the intake manifold and the connector can loosen from vibration. On VQ35HR (2007+ Maxima, Altima 3.5), the sensor location is different and more accessible. On VQ40 4.0L (Pathfinder, Xterra, Frontier), P0325 combined with a slight engine knock under load indicates genuine sensor failure; replacement requires intake manifold removal. Always confirm actual engine knock is not present before attributing P0325 purely to a sensor fault.
Most commonly affected models