2010 Ram P0306: What It Means & Is It Safe to Drive?
P0306 on the 2010 Ram: Cylinder 6 Misfire Detected. Here's what it means, what usually causes it, what repairs typically cost, and whether it's safe to keep driving.
What this code means
Misfire on cylinder 6, found on V6 and V8 engines. On transversely-mounted V6 engines the rear bank cylinders (including cylinder 6) often have higher labor costs due to access difficulty.
Common causes on the 2010 Ram
- Worn spark plug on cylinder 6
- Failed coil-on-plug
- Fuel injector fault
- Low compression
Symptoms
- Check Engine Light, may flash under load
- Rough idle or vibration
- Hesitation and power loss
Typical fixes
- Replace spark plug and COP coil on cylinder 6
- Replace or clean injector on cylinder 6
- Compression and leak-down test if no improvement
Repair cost range
For a 2010 Ram, repairs for P0306 typically fall between $150 and $1200, depending on the root cause and labor rates in your area.
Known issues on Ram
Ram HEMI P0306 is a rear-bank, non-MDS cylinder. A failed coil-on-plug or spark plug is the typical cause. On 6.4L HEMI trucks used for towing, plugs can foul from carbon buildup sooner than expected—inspect plug condition at every tune-up interval.
Most commonly affected models