2016 Ram P0340: What It Means & Is It Safe to Drive?
P0340 on the 2016 Ram: Camshaft Position Sensor Circuit Malfunction. Here's what it means, what usually causes it, what repairs typically cost, and whether it's safe to keep driving.
PowertrainHigh urgency
What this code means
The PCM is not receiving a valid signal from the camshaft position sensor. Affects ignition timing and fuel injection.
Common causes on the 2016 Ram
- Failed camshaft position sensor
- Wiring or connector issue
- Timing chain/belt misalignment (less common)
Symptoms
- Check Engine Light
- No start or hard start
- Rough run, stalling
- Reduced power
Typical fixes
- Replace camshaft position sensor
- Repair wiring/connector
- Verify timing if sensor replacement doesn't fix
Repair cost range
For a 2016 Ram, repairs for P0340 typically fall between $100 and $500, depending on the root cause and labor rates in your area.
Known issues on Ram
Ram P0340 cam position sensor fault on the Pentastar is typically a failed sensor or cam cover gasket leak contaminating the connector. On the HEMI, P0340 alongside ticking noise may indicate a VVT phaser issue that requires oil service history evaluation.
Most commonly affected models
Ram 1500 5.7L HEMI 2009–2021Ram 1500 3.6L Pentastar 2012–2021