What does code P0011 mean on a Ram and is it safe to drive?
P0011: Camshaft Position A – Timing Over-Advanced or System Performance (Bank 1). Here's what it means on your Ram, what usually causes it, what repairs typically cost, and how safe it is to keep driving.
What this code means
The intake camshaft on bank 1 is more advanced than the PCM commanded, or the VVT system isn't responding as expected. Often caused by low/dirty oil or a faulty oil control valve.
Common causes for your Ram
- Low or dirty engine oil (most common—change oil first)
- Failed or sludged oil control valve (OCV/VVT solenoid)
- Stretched or worn timing chain
- Stuck VVT actuator (cam phaser)
Symptoms
- Check Engine Light
- Rough idle or rattling on cold startup
- Poor fuel economy
- Reduced power
Typical fixes
- Oil change with correct viscosity oil (often resolves it)
- Clean or replace oil control valve
- Replace timing chain if stretched
- Replace cam phaser if faulty
Repair cost range
For a Ram, repairs for P0011 often fall between $50 and $1200, depending on the cause and whether you use OEM or aftermarket parts. Labor rates vary by location.
Known issues on Ram
Ram P0011 intake cam timing over-advanced on the Pentastar is almost always caused by dirty oil clogging the VVT solenoid screen. Change the oil with full synthetic first. On the HEMI, P0011 may indicate a VVT phaser reluctant to return—fresh oil at the correct viscosity resolves most cases.
Most commonly affected models