What does code P0341 mean on a Ram and is it safe to drive?
P0341: Camshaft Position Sensor Range/Performance. Here's what it means on your Ram, what usually causes it, what repairs typically cost, and how safe it is to keep driving.
What this code means
The camshaft position sensor signal is out of expected range or timing. Similar to P0340 but focused on performance rather than a hard fault.
Common causes for your Ram
- Weak camshaft position sensor
- Timing chain or belt stretched or jumped a tooth
- Wiring/connector problems
Symptoms
- Check Engine Light
- Hard starting, rough running, or stalling
- Reduced power or poor fuel economy
Typical fixes
- Replace camshaft position sensor
- Inspect and correct timing chain/belt issues
- Repair wiring/connectors
Repair cost range
For a Ram, repairs for P0341 often fall between $150 and $1200, depending on the cause and whether you use OEM or aftermarket parts. Labor rates vary by location.
Known issues on Ram
Ram Pentastar P0341 is typically a failed cam position sensor or connector corrosion. On the 5.7L HEMI, P0341 can come from a worn cam sensor reluctor ring on the intake cam. Check engine oil condition—low or dirty oil accelerates wear on the HEMI cam sensor.
Most commonly affected models