2010 Subaru P0301: What It Means & Is It Safe to Drive?
P0301 on the 2010 Subaru: Cylinder 1 Misfire Detected. Here's what it means, what usually causes it, what repairs typically cost, and whether it's safe to keep driving.
PowertrainHigh urgency
What this code means
The PCM has detected a misfire specifically on cylinder 1. Similar to P0300, but pinned to a single cylinder.
Common causes on the 2010 Subaru
- Worn or fouled spark plug on cylinder 1
- Failing ignition coil or coil-on-plug
- Leaking or clogged fuel injector
- Low compression in cylinder 1
Symptoms
- Check Engine Light (often flashing when misfire is severe)
- Rough idle or shaking, especially at low RPM
- Loss of power under load
Typical fixes
- Replace spark plug and/or coil on cylinder 1
- Test and clean or replace the injector
- Perform compression test and repair internal issues if needed
Repair cost range
For a 2010 Subaru, repairs for P0301 typically fall between $150 and $900, depending on the root cause and labor rates in your area.
Known issues on Subaru
On EJ-series Subaru engines, a P0301 often signals a head gasket leak on cylinder 1 allowing coolant into the combustion chamber. Check for white exhaust smoke at startup and a milky residue on the oil cap. Ignition diagnosis should come after ruling out the head gasket.
Most commonly affected models
Outback EJ25 2000–2009Forester EJ25 2006–2010Impreza WRX EJ20 2002–2014