2011 Toyota P0306: What It Means & Is It Safe to Drive?

P0306 on the 2011 Toyota: Cylinder 6 Misfire Detected. Here's what it means, what usually causes it, what repairs typically cost, and whether it's safe to keep driving.

PowertrainHigh urgency

What this code means

Misfire on cylinder 6, found on V6 and V8 engines. On transversely-mounted V6 engines the rear bank cylinders (including cylinder 6) often have higher labor costs due to access difficulty.

Common causes on the 2011 Toyota

  • Worn spark plug on cylinder 6
  • Failed coil-on-plug
  • Fuel injector fault
  • Low compression

Symptoms

  • Check Engine Light, may flash under load
  • Rough idle or vibration
  • Hesitation and power loss

Typical fixes

  • Replace spark plug and COP coil on cylinder 6
  • Replace or clean injector on cylinder 6
  • Compression and leak-down test if no improvement

Repair cost range

For a 2011 Toyota, repairs for P0306 typically fall between $150 and $1200, depending on the root cause and labor rates in your area.

Known issues on Toyota

P0306 on Toyota 2GR-FE V6 is a rear-bank, firewall-side cylinder. Access requires removing the intake plenum. Rear-bank coil failures are more common due to heat soak. Confirm the fault before pulling the intake—swap via the front-bank coil first.

Most commonly affected models

Camry V6 2GR-FE 2007–2011Highlander V6 2008–2013Sienna V6 2011–2020

Is it safe to keep driving your 2011 Toyota with this code?

For driving-safety guidance—how far you can go, when to tow, and what's urgent—see these checklists:

See all codes for your Toyota

Looking for a different code, or want the full guide without the year filter?