What does code P0335 mean on a Volkswagen and is it safe to drive?
P0335: Crankshaft Position Sensor A Circuit Malfunction. Here's what it means on your Volkswagen, what usually causes it, what repairs typically cost, and how safe it is to keep driving.
What this code means
The PCM is not receiving the expected signal from the crankshaft position sensor (CKP). This sensor tells the ECM the exact position and speed of the crankshaft. Without it, the engine may not start or will stall and run poorly.
Common causes for your Volkswagen
- Failed crankshaft position sensor
- Damaged or corroded sensor wiring/connector
- Tone ring (reluctor wheel) damage or debris
- Failed PCM (rare)
Symptoms
- Engine won't start or stalls unexpectedly
- Check Engine Light on
- Engine cranks but will not fire
- Intermittent stalling at speed
Typical fixes
- Replace crankshaft position sensor
- Inspect and repair wiring harness and connector
- Check tone ring for damage or packed debris
Repair cost range
For a Volkswagen, repairs for P0335 often fall between $100 and $350, depending on the cause and whether you use OEM or aftermarket parts. Labor rates vary by location.
Known issues on Volkswagen
VW 2.0T TSI P0335 is sometimes caused by timing chain stretch affecting CKP signal correlation—check for cam/crank timing codes alongside P0335. A failed sensor alone is also a common standalone cause.
Most commonly affected models